I saved this cedar from the chop back in 2008. It was growing as a tall tree in the middle of a lawn. The owner wanted it removed as it was ruining the lines created by his lawnmower! There was 4 of them but this was the only survivor from collection. They had strimmer damage and very poor roots.
I wasn’t sure if it would even make a tree and to be honest the jury is still out on that point!! It is very straight and resembles a fence post. I don’t have the photos from the first shaping back in 2009. It was just branch selection and some primary branch wiring done to drop the branches.
A short time later I wanted to practice my carving and decided this would make a good practice piece. I wasn’t too worried about it and I thought that carving might add interest to the trunk and take away from the straightness.
You can see that I need the practice!! I then wired the tree to replace the branches at the right angles. This all took place over a 4 month period.
I wasn’t overly happy with the result. I considered lowering the height of the tree and perhaps creating a jinned apex like the virtual below. However, I wanted two tall trees that would eventually sit either side of a gate into the bonsai section of my garden. I have another one of a similar size and style and decided to keep it the full height. This meant keeping the cheat of an apex.
This is another virtual done back in2010
Yesterday I brought it into the garage and started to tidy up the weeds in the pot and and remove old needles. Before I knew it the wire was out again! Lots of growth in the last year with enough extension that I could hopefully improve the image. Branches have sprung up and needed to be brought back down again.
Me for scale.
After four hours this was the best I could come up with. I had to take it slow and steady with my dodgy shoulder but I got there in the end. I was able to use foliage to hide the bad apex.
Still a lot I’m not happy with but perhaps some day it’ll be worth all the effort. I do have a soft spot for that lovely blue foliage 🙂